K9 Body Control Module X6

2025 Chevrolet Tahoe Commercial, 4WDSECTION K9 Body Control Module X6
GM5202291Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type:Body Wiring Harness
  • OEM Connector: 160028-0017
  • Service Connector: 13534981
  • Description: 32-Way F 0.5 MQS, 1.2 OCS Series (BN with GY Inner Connector)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool
I 19370262 EL-35616-58 (BK) EL-38125-58
II 84729890 J-35616-12 (BU) J-38125-215A
Pin Size Color Circuit Function Terminal Type ID Option
1 - - - Not Occupied - -
2 0.75 VT / WH 1094 Right Rear Door Lock Actuator Lock Control II -
3 0.75 GY / BK 2680 Lock Actuators Unlock Control 2 II -
4 - - - Not Occupied - -
5 0.35 YE / BU 5797 Rear Closure Handle Switch Open Signal I -
6 - - - Not Occupied - -
7 0.35 BN / GN 3568 Rear Closure Passive Entry Antenna High Signal I -
8 0.35 GN / GY 3569 Rear Closure Passive Entry Antenna Low Signal I -
9 - 10 - - - Not Occupied - -
11 0.35 GN / BU 6133 Body Control Module LIN Bus 2 I -
12 - 16 - - - Not Occupied - -
17 0.35 BU / BN 8917 Left Front Door Ajar Switch Signal 2 I -
18 - 21 - - - Not Occupied - -
22 0.35 BN / GN 4064 Hood Status B Signal I -
23 - 27 - - - Not Occupied - -
28 0.35 BU 2675 Left Front Exterior Door Handle Switch Unlock Signal I -
29 - 30 - - - Not Occupied - -
31 0.35 GY / BU 4995 Right Rear Door Exterior Switch Unlock Signal I -
32 - - - Not Occupied - -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.