Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK212 GEAR SHIFT CONTROL MODULE: PROGRAMMING AND SETUPREPLACE AND PROGRAM CONTROL MODULE OR REPROGRAM CONTROL MODULE
2025 Chevrolet Tahoe Commercial, 4WD
Replace and Program Control Module or Reprogram Control Module
2025 Chevrolet Tahoe Commercial, 4WDSECTION Replace and Program Control Module or Reprogram Control Module
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K212 Gear Shift Control Module - Programming and follow the on-screen instructions.
- Clear DTCs.
- If DTCs U1962 and U1972 set, perform Serial Data Authentication Configuration procedure: Serial Data Authentication Configuration .
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.