Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Connect the electrical connector to the windshield wiper system module until the lock engages fully.
- Pull back lightly on the electrical connector to ensure the lock is engaged.
- Install the windshield wiper system module (2) in the vehicle.
- Windshield Wiper System Module Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Install the retainers.
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1 / 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
Windshield Wiper System Module Shield (1) - Install
Air Inlet Grille Panel (2) - Install
- Rear Window Washer Nozzle Extension Hose - Connect [2x]
- Rear Window Washer Solvent Container Hose - Connect
- Air Inlet Grille Panel Retainer (1) - Install [8x]
Hood Rear Outer Air Inlet Seal - Left Side and Right Side (2) - Install [2x]
- Air Inlet Grille Panel Retainer - Left Side and Right Side (1) - Install [2x]
Air Inlet Grille Panel Extension - Right Side (1) - Install
- Air Inlet Grille Panel Retainer (2) - Install
- Remove the double layer of masking tape around the perimeter of the painted surfaces.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Air Inlet Grille Panel Extension - Left Side (1) - Install
- Remove the double layer of masking tape around the perimeter of the painted surfaces.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Clean the left and right side windshield wiper transmission pivot shaft splines with a soft wire brush before installing the windshield wiper arms (3).
- Position the windshield wiper arms (3) on the windshield wiper transmission pivot shaft.
- Windshield Wiper Arm Nut - Left Side and Right Side (2) - Install and tighten [2x] - Fastener Specifications
- Windshield Wiper Arm Finish Cap - Left Side and Right Side (1) - Install [2x]
If required, realign the windshield wipers to their respective alignment circles (1) on the windshield.
- Lubricate the windshield with clean washer fluid.
- Run the windshield wipers for two complete cycles then turn off the windshield wipers.
- Ensure the windshield wipers are in the full park position.
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.