Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSB174W FRONT VIEW CAMERA - WINDSHIELD: PROGRAMMING AND SETUPREPLACE AND PROGRAM FRONTVIEW CAMERA MODULE OR REPROGRAM FRONTVIEW CAMERA MODULE (WITHOUT UGN)
2025 Chevrolet Tahoe Commercial, 4WD
Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
2025 Chevrolet Tahoe Commercial, 4WDSECTION Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing B174W Frontview Camera - Windshield, perform the following procedure:
- Ignition/Vehicle OFF
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Setup (if this option is available) and follow the on-screen instructions.
- Clear DTCs.
- Following B174W Frontview Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera - Windshield Learn .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.