Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TAHOE COMMERCIAL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMS - DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC INFORMATION AND PROCEDURESDTC P0607CIRCUIT/SYSTEM VERIFICATION
2025 Chevrolet Tahoe Commercial, 4WD
Circuit/System Verification
2025 Chevrolet Tahoe Commercial, 4WDSECTION Circuit/System Verification
- Verify no other DTCs are set, except DTC P0607.
- If any other DTCs are set
Diagnose all other DTCs first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no other DTCs are set
- If any other DTCs are set
- Program the K124 Image Processing Module. Refer to Control Module References
- Clear DTCs and operate the vehicle in the conditions that the customer experienced.
- Verify DTC P0607 does not set.
- If the DTC sets
Replace the K124 Image Processing Module.
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.