Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Using the scan tool, deflate the automatic level control air supply reservoir and the 4 air springs.
- Remove the spare tire and wheel assembly.
Electrical Connector (2) - Remove
- Remove the 7 automatic level control air compressor tube fitting (1) from the air suspension controller.
- Using a suitable tool, slightly open the split in the bite rings located under automatic level control air compressor tube fittings.
- Remove and DISCARD the 7 old automatic level control air compressor tube fittings (1) from the 7 automatic level control air compressor tubes.
Remove the 2 automatic level control solenoid bolts (1).
Remove the air suspension controller (1) and air suspension control module as an assembly.
Automatic Level Control Air Compressor Bolt (1) - Remove [2x]
- Air Suspension Control Module (3) - Remove
Service mode will be automatically enabled when the ride height sensors detect the vehicle has been lifted off the ground. Service mode will automatically be disabled when the vehicle reaches 16 km/h (10 MPH).
The new automatic level control module air suspension controller will have new automatic level control air compressor tube fittings installed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.