Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2025 Chevrolet Suburban LS, RWDSECTION Installation Procedure
Install the power steering control module wiring power harness (1).
- Install the power steering control module wiring power harness clip (2) to the electric belt drive rack and pinion steering gear housing.
- Connect the power steering control module wiring power harness (1) to the power steering assist motor.
Connect the power steering control module wiring power harness (2) to the main power steering wiring harness (1).
Install the power steering assist motor wire clip (3).
- Position the power steering control module wiring power harness (1) into the 2 retaining clips (2).
- Install underbody panels as necessary. Underbody Panel Component Locator
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1 / 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.