Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Starting in the upper corners of the liftgate window weatherstrip (1), push firmly to install onto the weld flange.
- Liftgate Window Weatherstrip (1) - Install
Rear Window Defroster Electrical Connector (2) - Connect [2x]
- Rear Window Defroster Electrical Connector Trim Cover (1) - Install [2x]
Liftgate Lower Trim Finish Panel Access Hole Cover (2) - Install
- Liftgate Trim Finish Panel Locator (1) - Install [2x]
- Close the liftgate window.
- Ensure the window operates properly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.