Removal Procedure

2025 Chevrolet Suburban LS, RWDSECTION Removal Procedure
  1. GM6713308Courtesy of GENERAL MOTORS COMPANY

    Front Side Door Armrest Pull Cup Bolt Cap (1) - Remove

  2. Front Side Door Trim Panel Bolt (2) - Remove
  3. Using a flat bladed plastic trim tool, start at the rear of the front side door accessory switch mount plate (3) and gently insert trim tool to lift the front side door accessory switch mount plate from the door trim.
  4. Rotate the front side door accessory switch mount plate (3) up and rearward to unhook the front retaining feature.
  5. Disconnect the electrical connectors.
  6. Front Side Door Accessory Switch Mount Plate - Driver Side (3) - Remove
  7. GM6713451Courtesy of GENERAL MOTORS COMPANY

    Release the front side door window control switch (1) from the switch mount plate by depressing the tabs along each side of the switch.

  8. Front Side Door Window Control Switch (1) - Remove
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.