SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025SUBURBAN LS, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK180 DRIVER MONITORING SYSTEM CONTROL MODULE: PROGRAMMING AND SETUPREPLACE AND PROGRAM CONTROL MODULE OR REPROGRAM CONTROL MODULE
2025 Chevrolet Suburban LS, RWD

Replace and Program Control Module or Reprogram Control Module

2025 Chevrolet Suburban LS, RWDSECTION Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

  1. Ignition/Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K180 Driver Monitoring System Control Module - Programming and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select K180 Driver Monitoring System Control Module - Setup (If Applicable) and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select K180 Driver Monitoring System Control Module - Configuration (If Applicable) and follow the on-screen instructions.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.