Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025SUBURBAN LS, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK124 IMAGE PROCESSING MODULE: PROGRAMMING AND SETUPREPROGRAM IMAGE PROCESSING MODULE
2025 Chevrolet Suburban LS, RWD
Reprogram Image Processing Module
2025 Chevrolet Suburban LS, RWDSECTION Reprogram Image Processing Module
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To reprogram an existing K124 Image Processing Module, perform the following procedure:
- Ignition/Vehicle OFF
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K124 Image Processing Module - Programming and follow the on-screen instructions.
- Clear DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.