Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025SUBURBAN LS, 4WDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSLIFTGATE WINDOW WEATHERSTRIP REPLACEMENTREMOVAL PROCEDURE
2025 Chevrolet Suburban LS, 4WD
Removal Procedure
2025 Chevrolet Suburban LS, 4WDSECTION Removal Procedure
- Open the liftgate window.
Use a small flat-bladed tool to remove the 2 panel locators (1).
- Liftgate Lower Trim Finish Panel Access Hole Cover (2) - Remove
Rear Window Defroster Electrical Connector Trim Cover (1) - Remove [2x]
- Rear Window Defroster Electrical Connector (2) - Disconnect [2x]
Starting in the center, pull and roll the liftgate window weatherstrip (1) to remove.
- Liftgate Window Weatherstrip (1) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.