Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The S126 Ride Control Switch is a normally open switch that closes when the switch is pressed. The K9 Body Control Module monitors the switch on signal circuit 2203. The S126 Ride Control Switch uses circuit 1449 for a low reference. When the drive mode select switch is not pressed, the switch is open and signal voltage observed by the K9 Body Control Module is high. When the drive mode select switch is pressed, the switch is closed and signal voltage observed by the K9 Body Control Module is low.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.