Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, FWDREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMSPECIFICATIONSFASTENER SPECIFICATIONS
2025 Chevrolet Equinox RS, FWD
Fastener Specifications
2025 Chevrolet Equinox RS, FWDSECTION Fastener Specifications
Electric Belt Drive Rack and Pinion Steering Gear
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Gear Boot Inner Clamp [2x] | Yes | - | - | Steering Gear Boot Replacement |
| 2 | Steering Gear Bolt [2x] | - | - | 100 N.m (74 lb ft) Second Pass: 45-60 degrees |
Electric Dual Pinion Rack and Pinion Steering Gear Replacement , or Electric Dual Pinion Rack and Pinion Steering Gear Replacement |
Steering Linkage
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Steering Linkage Inner Tie Rod | - | - | 105 N.m (77 lb ft) | Steering Linkage Inner Tie Rod Replacement |
| 2 | Steering Linkage Outer Tie Rod Nut | - | - | First Pass: 35 N.m (26 lb ft) Second Pass: 80-90 degrees |
Steering Linkage Outer Tie Rod Replacement |
Steering Linkage
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
|---|---|---|---|---|---|
| Metric (English) | |||||
| 1 | Power Steering Assist Motor Bolt [2x] | Yes | - | 21 N.m (15 lb ft) | Power Steering Assist Motor Replacement |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.