Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, FWDREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK71 TRANSMISSION CONTROL MODULE: PROGRAMMING AND SETUP (8T45 (MGH))REPROGRAM CONTROL MODULE AFTER TRANSMISSION REPAIR/REPLACEMENT
2025 Chevrolet Equinox RS, FWD
Reprogram Control Module after Transmission Repair/Replacement
2025 Chevrolet Equinox RS, FWDSECTION Reprogram Control Module after Transmission Repair/Replacement
To program an existing K71 Transmission Control Module, after a transmission repair/replacement, perform the following procedure:
- Install EL-49642 SPS programming support tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- Perform the SPS Transmission Control Module programming event. Choose one of the following screen prompts:
- Select Transmission Control Module - MCVM Operations, and follow the on-screen instructions. This will update the Solenoid Characterization data only.
- Select Transmission Control Module - Programming and follow the on-screen instructions. This will update the TCM calibration and the Solenoid Valve Characterization data.
- Perform the Vehicle Setup, follow the on screen instructions.
- With a scan tool, clear DTCs from the K71 Transmission Control Module.
- Perform the scan tool configuration/reset function: Transmission Service Fast Learn - If available
- Ignition OFF for 2 minutes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.