Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 73 (POWER SEATS)DIAGNOSTIC INFORMATION AND PROCEDURESMEMORY SEAT FEATURE MALFUNCTIONCIRCUIT/SYSTEM TESTING
2025 Chevrolet Equinox RS, FWD
Circuit/System Testing
2025 Chevrolet Equinox RS, FWDSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, all vehicle systems OFF, disconnect the harness connector at the S47D Seat Memory Switch - Driver. It may take up to 2 min for all vehicle system to power down.
- Test for less than 10 Ω between the ground circuit terminal 1 and ground.
- If 10 Ω or greater
- Ignition OFF.
- Test for less than 2 Ω in the ground circuit end to end
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, repair the open/high resistance in the ground connection.
- Go to next step: If less than 10 Ω
- Ignition ON, press a power seat switch in order to wake up the K40D Seat Memory Control Module - Driver.
- Test for 9 V or greater between each signal circuit terminal listed below and ground:
- Memory set switch signal terminal 5
- Memory switch signal terminal 6
- If less than 9 V
- Ignition OFF, disconnect the X6 harness connector at the K40D Seat Memory Control Module - Driver.
- Test for infinite resistance between the signal circuit and ground.
- If less than infinite resistance, repair the short to ground on the circuit.
- Go to next step: If infinite resistance
- Test for less than 2 Ω in the signal circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, replace the K40D Seat Memory Control Module - Driver.
- Go to next step: If 9 V or greater
- Ignition OFF, disconnect the X6 harness connector at the K40D Seat Memory Control Module - Driver, ignition ON.
- Test for less than 1 V between each signal circuit terminal listed below and ground:
- Memory set switch signal terminal 5
- Memory switch signal terminal 6
- If 1 V or greater
Repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
- Test or replace the S47D Seat Memory Switch - Driver.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.