Unsuccessful Programming Recovery

2025 Chevrolet Equinox RS, FWDSECTION Unsuccessful Programming Recovery
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

In the event of an interrupted or unsuccessful programming event, perform the following:

  1. Ignition ON. Ensure the control module, DLC, and programming tool connections are secure and the SPS software is up to date.
  2. Verify the control module can be reprogrammed.
    • If the control module cannot be programmed 
    1. Ignition OFF for 2 minutes, ignition ON.
    2. Verify the control module can be reprogrammed.
      • If the control module cannot be programmed, replace the K71 Transmission Control Module.
    • Go to next step: If the control module can be reprogrammed 
  3. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.