Installation Procedure

2025 Chevrolet Equinox RS, FWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4967476Courtesy of GENERAL MOTORS COMPANY

    Route the connector through the accessory power receptacle retainer. Align the retainer to the slot in the opening.

  2. Install the retainer by pressing into place until fully seated.
  3. Connect the electrical connector to the accessory power receptacle (1).
  4. Align the tabs on the receptacle (1) to the slots in the retainer. Install the accessory power receptacle by pressing into place until fully seated.
  5. Install the auxiliary power outlet fuse.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.