Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, FWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (IMAGE DISPLAY CAMERAS)REPAIR INSTRUCTIONSVIDEO PROCESSING CONTROL MODULE CALIBRATIONDIAGNOSTIC AIDS
2025 Chevrolet Equinox RS, FWD
Diagnostic Aids
2025 Chevrolet Equinox RS, FWDSECTION Diagnostic Aids
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Ideal conditions to reduce the time needed for the Video Processing Control Module to complete the calibration include:
- All moving points of vehicle access (doors, trunk/liftgate, fuel door, hood, etc) of the vehicle Must be closed and the corresponding vehicle access systems functional (no DTCs, etc).
- No vehicle body or structural damage that may affect proper camera mounting or line of sight
- All surround vision cameras properly mounted, fully connected, and appropriately connected to the proper terminal of the Video Processing Control Module.
- Vehicle driven reasonably flat and straight for at least 0.5 km (0.3 miles)
- Vehicle speed between 10 - 30 kph (6-19 mph)
- Steering wheel angle less than 0.5°
- It is a good practice to wipe camera lens' clean prior to alignment
- Vehicle should not be within 1.5 meters (5 feet) of a curb or roadside
- Dry weather, cloudy but bright sky
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.