Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Connect the electrical connector.
Side View Driver Information Camera (2) - Install
- Side View Driver Information Camera Bracket (1) - Install
- CAUTION:
Refer to Fastener Caution .
Side View Driver Information Camera Bracket Bolt (1) - Install and tighten [2x] 0.5 N.m (4 lb in)
Push the outside rearview mirror housing bezel (1) into the retaining clips until seated.
Outside Rearview Mirror Inner Actuator (2) - Install - Outside Rearview Mirror Actuator Replacement
- Connect the electrical connectors.
Outside Rearview Mirror Glass (1) - Install - Outside Rearview Mirror Glass Replacement
NOTE:Inspect the outside rearview mirror for proper operation.
- Perform the necessary calibration and setup procedure: Video Processing Control Module Calibration
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.