Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Serial Data Gateway Module (1) - Install
Connect the electrical connectors.
- Serial Data Gateway Bracket (2) - Install
- Serial Data Gateway Module Bracket Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Radio Control Assembly (2) - Install - Radio Control Assembly Replacement (Equinox) , or Radio Control Assembly Replacement (Terrain)
Instrument Panel Trim Pad - Right Side (1) - Install - Instrument Panel Trim Pad Replacement - Right Side (Equinox) , or Instrument Panel Trim Pad Replacement - Right Side (Terrain)
Install the left and right instrument panel center trim plate applique (1, 2). Instrument Panel Center Trim Plate Applique Replacement (Terrain)
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.