K219 Lighting Control Module X2

2025 Chevrolet Equinox RS, FWDSECTION K219 Lighting Control Module X2
GM5203807Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type: Body Wiring Harness
  • OEM Connector: 13534966
  • Service Connector: 13534966
  • Description: 25-Way F 0.5 MQS, 2.8 MCP Series (GY with GY Inner Connector)
Terminal Part Information

Terminal Type ID Terminated Lead Diagnostic Test Probe Terminal Removal Tool
I 19370262 EL-35616-58 (BK) EL-38125-58
II 87814662 J-35616-4A (PU) J-38125-557
Pin Size Color Circuit Function Terminal Type ID Option
1 0.35 YE 312 Right Headlamp Low Beam Control I -
2 0.35 GN / VT 1315 Right Front Turn Signal Lamp Control I -
3 0.35 BN / GY 2268 Windshield Washer Relay Control I -
4 0.35 WH 711 Left Headlamp High Beam Control I -
5 - 9 - - - Not Occupied - -
10 0.35 BN / GN 196 Windshield Wiper Motor Park Switch Signal I -
11 0.35 VT / BK 6568 Front Turn Signal Lamp Feedback Signal I -
12 0.35 GY 91 Windshield Wiper Motor Relay Coil Control I -
13 - - - Not Occupied - -
14 0.35 VT 185 Low Washer Fluid Indicator Control I -
15 0.35 YE 5420 Rear Wiper Motor Relay Coil Control I -
16 0.35 YE / BU 318 Left Rear Trailer Stop/Turn Lamp Control I SDE
17 0.35 BU / WH 1314 Left Front Turn Signal Lamp Control I -
18 0.35 WH 311 Right Headlamp High Beam Control I -
19 0.35 YE 712 Left Headlamp Low Beam Control I -
20 0.35 WH / YE 7545 Right Front Turn Signal Lamp Feedback Signal I -
21 0.35 WH / VT 860 Windshield Wiper Switch High Signal I -
22 0.75 RD / YE 4340 Battery Positive Voltage II -
23 0.75 RD / GN 4440 Battery Positive Voltage II -
24 - 25 - - - Not Occupied - -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.