Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- NOTE:
The bracket is fragile. Remove it carefully
Communication Interface Module Bracket (2) - Install
- Install the connector clip (1)
Telematic Control Module (1) - Install
- Ensure that the retaining tabs are fully secured.
- Connect the electrical connectors.
Headlining Trim Panel (1) - Install
- Install the 2 headlining trim panel retainers.
- NOTE:
Left side shown, right side similar.
Quarter Window Trim Finish Panel- Left Side and Right Side (1) - Install [2x]
- NOTE:
Left side shown, right side similar.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.