Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, 4WDREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMS
2025 Chevrolet Equinox RS, 4WD
Programming And Setup - All Systems
2025 Chevrolet Equinox RS, 4WDSECTION Programming And Setup - All Systems
- Diagnostic Information and Procedures
- Repair Instructions
- A11 Radio: Programming and Setup
- A26 Heater and Air Conditioning User Interface Control - Front: Programming and Setup
- B174W Front View Camera - Windshield: Programming and Setup
- B218L Side Obstacle Detection Control Module - Left: Programming and Setup
- B218R Side Obstacle Detection Control Module - Right: Programming and Setup
- B233B Forward Range Radar Sensor - Long Range: Programming and Setup
- B233R Short Range Radar Sensor - Rear: Programming and Setup
- K9 Body Control Module: Programming and Setup
- K20 Engine Control Module: Programming and Setup
- K212 Gear Shift Control Module: Programming and Setup
- K219 Lighting Control Module: Programming and Setup
- K29FV Front Seat Heater Vent Control Module: Programming and Setup
- K29R Rear Seat Heater Control Module: Programming and Setup
- K36 Restraints Control Module: Programming and Setup
- K40D Driver Seat Adjuster Memory Module: Programming and Setup
- K43 Power Steering Control Module: Programming and Setup
- K47 Power Transfer Unit Actuator Control Module: Programming and Setup
- K56 Serial Data Gateway Module: Programming and Setup
- K61 Sunroof Control Module: Programming and Setup
- K71 Transmission Control Module: Programming and Setup (8T45 (MGH))
- K71 Transmission Control Module: Programming and Setup (VT40 (MRQ))
- K73 Telematic Control Module: Programming and Setup
- K85P Restraints Occupant Classification System Module - Passenger: Programming and Setup
- K160 Brake System Control Module: Programming and Setup
- K182 Parking Assist Control Module: Programming and Setup
- K194 Rear Gate Module: Programming and Setup
- T1 Accessory AC and DC Power Control Module: Programming and Setup
- T22 Wireless Accessory Charging Module: Programming and Setup
- K111 Fuel Pump Power Control Module: Programming and Setup
- Serial Data Authentication Configuration
- Service Programming System (SPS)
- Q77 Transmission Control Solenoid Valve Characterization Programming (MGH)
- Q77 Transmission Control Solenoid Valve Characterization Programming (MRQ)
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.