Installation Procedure

2025 Chevrolet Equinox RS, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Accessory AC and DC Power Control Module (2) - Install
  2. Connect the electrical connector.
  3. Accessory AC and DC Power Control Module Bolt (1) - Install and tighten [3x] 2.5 N.m (22 lb in)
  4. GM4743953Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Rear Trim Panel - Right Side (1) - Install

  5. GM4743952Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Rear Trim Panel - Left Side (1) - Install

  6. GM4570315Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Rear Trim Panel (2) - Install - Front Floor Console Rear Trim Panel Replacement (Equinox) , or Front Floor Console Rear Trim Panel Replacement (Terrain)

  7. GM4741732Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console (1) - Install - Front Floor Console Replacement (Equinox) , or Front Floor Console Replacement (Terrain) , or Front Floor Console Replacement (Terrain 2022)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.