Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing
2025 Chevrolet Equinox RS, 4WDSECTION Component Testing
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: S3 Transmission Shift Lever
- Connect a 3 A fused jumper wire between the test points: Control terminal 4 & 12 V
- Momentarily connect a jumper wire between the test points: Ground terminal 2 & Ground
Verify the component produces a clicking sound: M7 Transmission Shift Lock Control Solenoid Actuator
- If the component does not produce a sound
Replace the component: S3 Transmission Shift Lever
- Go to next step: If the component produces a sound
- If the component does not produce a sound
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.