Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSCOMPONENT CONNECTOR END VIEWS (K9-K56)COMPONENT CONNECTOR END VIEWSK9 BODY CONTROL MODULE X6
2025 Chevrolet Equinox RS, 4WD
K9 Body Control Module X6
2025 Chevrolet Equinox RS, 4WDSECTION K9 Body Control Module X6
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool |
|---|---|---|---|
| I | 19370262 | EL-35616-58 (BK) | EL-38125-58 |
| II | 84729890 | J-35616-12 (BU) | J-38125-215A |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | - | - | - | Not Occupied | - | - |
| 2 | 0.75 | VT / WH | 1094 | Right Rear Door Lock Actuator Lock Control | II | - |
| 3 | 1.5 | GY / BK | 2680 | Lock Actuators Unlock Control 2 | II | - |
| 4 | - | - | - | Not Occupied | - | - |
| 5 | 0.35 | YE / BU | 5797 | Rear Closure Handle Switch Open Signal | I | - |
| 6 | - | - | - | Not Occupied | - | - |
| 7 | 0.35 | BN / GN | 3568 | Rear Closure Passive Entry Antenna High Signal | I | |
| 8 | 0.35 | GN / GY | 3569 | Rear Closure Passive Entry Antenna Low Signal | I | |
| 9 - 13 | - | - | - | Not Occupied | - | - |
| 14 | 0.35 | WH / VT | 12481 | Hands Free Closure Release Sensor Alarm Control | I | TCP |
| 15 - 21 | - | - | - | Not Occupied | - | - |
| 22 | 0.35 | BN / GN | 4064 | Hood Status B Signal | I | - |
| 23 - 27 | - | - | - | Not Occupied | - | - |
| 28 | 0.35 | BU | 2675 | Left Front Exterior Door Handle Switch Unlock Signal | I | |
| 29 - 32 | - | - | - | Not Occupied | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.