Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX RS, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS AND FUEL - 1.5L (LSD) - REPAIR INSTRUCTIONS (2 OF 2)REPAIR INSTRUCTIONSFUEL PUMP POWER CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2025 Chevrolet Equinox RS, 4WD
Installation Procedure
2025 Chevrolet Equinox RS, 4WDSECTION Installation Procedure
Fuel Pump Power Control Module (3) - Install
- Fuel Pump Power Control Module Bolt (2) - Install and tighten - Fastener Specifications
- Fuel Pump Power Control Module Nut (1) - Install and tighten - Fastener Specifications
- Connect the electrical connector.
- Underbody Rear Air Deflector - Install - Underbody Rear Air Deflector Replacement
- Fuel Pump Power Control Module: Programming and Setup. K111 Fuel Pump Power Control Module: Programming and Setup
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.