Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2025 Chevrolet Equinox RS, 4WDSECTION Installation Procedure
Ensure the retaining tabs are properly aligned.
- Side Object Sensing Alert Module (3) - Install
- Side Object Sensing Alert Module Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector. (1)
- Remove the support and lower the vehicle. Lifting and Jacking the Vehicle
- Perform the necessary programming and setup procedure: - Control Module References
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.