Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE DYNAMICS SENSOR REPLACEMENTINSTALLATION PROCEDURE
2025 Chevrolet Equinox EV RS, AWD
Installation Procedure
2025 Chevrolet Equinox EV RS, AWDSECTION Installation Procedure
Vehicle Dynamic Sensor (1) - Install
- Vehicle Dynamic Sensor Nut (2) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector. (3)
Front Floor Console (1) - Install - Front Floor Console Removal and Installation
- Perform the vehicle dynamic sensor offset calibration. Vehicle Dynamic Sensor Offset Calibration
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.