Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE DYNAMIC SENSOR OFFSET CALIBRATIONK124 IMAGE PROCESSING MODULE, B284 VEHICLE DYNAMIC SENSOR REPLACEMENT OR DTC C0520
2025 Chevrolet Equinox EV RS, AWD
K124 Image Processing Module, B284 Vehicle Dynamic Sensor Replacement or DTC C0520
2025 Chevrolet Equinox EV RS, AWDSECTION K124 Image Processing Module, B284 Vehicle Dynamic Sensor Replacement or DTC C0520
The vehicle dynamic sensor learn procedure can be completed with a scan tool using the following steps:
- Place vehicle on a level surface
- Apply the parking brake, or set the transmission in the Park position.
- Install the scan tool to the data link connector.
- Ignition ON/Vehicle in Service Mode
- Select Vehicle Dynamic Sensor Offset Calibration in the K124AB Image Processing Module 1 - Processor 2 Configuration/Reset Functions list.
- Follow the scan tool directions to complete the calibration procedure.
- Clear any DTCs that may be set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.