Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Low Frequency Console Number 2 Antenna (1) - Install
Connect the electrical connectors.
- Front Floor Console Rear Trim Panel (1) - Install
- CAUTION:
Refer to Fastener Caution .
Front Floor Console Rear Cover Bolt (1) - Install and tighten [6x] - Fastener Specifications
- NOTE:
Some components not shown for graphic clarity.
Front Floor Console Side Trim Panel - Left Side and Right Side (1) - Install [2x]
- Return the seats to the original position.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.