Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Drive Motor Power Distribution Control Module Removal
Drive Motor Power Distribution Control Module High Voltage Connector Cover Bolt (1) - Remove [3x]
- Drive Motor Power Distribution Control Module High Voltage Connector Access Cover (2) - Remove
Using a magnetic socket, remove the 3 drive motor power inverter module connector bolts (1).
Drive Motor Power Inverter Module Bolt (1) - Remove [17x]
- Drive Motor Power Distribution Control Module (2) - Remove
- Drive Motor Power Inverter Module Gasket (3) - Remove
Drive motor power distribution control module high voltage connector access cover seal is not serviceable separately.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.