Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Drive Motor Power Distribution Control Module Installation
Drive Motor Power Inverter Module Gasket (1) - Install
- Drive Motor Power Distribution Control Module (2) - Install
- Drive Motor Power Inverter Module Bolt (3) - Install and tighten in sequence [17x] - Fastener Specifications
Using a magnetic socket, install and tighten the 3 drive motor power inverter module connector bolts (1). Fastener Specifications
- NOTE:
Drive motor power distribution control module high voltage connector access cover seal is not serviceable separately.
Drive Motor Power Distribution Control Module High Voltage Connector Access Cover (1) - Install
- Drive Motor Power Distribution Control Module High Voltage Connector Cover Bolt (2) - Install and tighten [3x] - Fastener Specifications
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.