Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK124 IMAGE PROCESSING MODULE: PROGRAMMING AND SETUP (WITH UKL)UNSUCCESSFUL PROGRAMMING RECOVERY
2025 Chevrolet Equinox EV RS, AWD
Unsuccessful Programming Recovery
2025 Chevrolet Equinox EV RS, AWDSECTION Unsuccessful Programming Recovery
In the event of an interrupted or unsuccessful setup event, perform the following steps:
- Ignition/Vehicle OFF.
- Ensure the Image Processing Module, DLC and programming tool connections are secure and the SPS software is up to date.
- Ignition/Vehicle OFF, all access doors closed, all vehicle systems OFF for two minutes.
- Attempt to reprogram the K124 Image Processing Module
- Verify the K124 Image Processing Module can be reprogrammed.
- If the image processing module cannot be reprogrammed, contact Techline Customer Support Center (TCSC).
- Go to next step: If the K124 Image Processing Module can be reprogrammed.
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.