Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK107B DRIVE MOTOR 2 CONTROL MODULE: PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY

2025 Chevrolet Equinox EV RS, AWD

Unsuccessful Programming Recovery

2025 Chevrolet Equinox EV RS, AWDSECTION Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
Verify the control module programming is successful.
- If the programming is not successful
1. Vehicle Off. Wait for greater than 1 min.
2. Vehicle OnService Mode
3. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
  - If the programming is not successful, Replace the appropriate component: Drive Motor Control Module that was not able to program.
  - Go to next step: If the programming is successful
4. All OK.
- Go to next step: If the programming is successful
All OK..

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.