Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSPLUG-IN CHARGINGDIAGNOSTIC INFORMATION AND PROCEDURESDTC U1015CIRCUIT/SYSTEM VERIFICATION
2025 Chevrolet Equinox EV RS, AWD
Circuit/System Verification
2025 Chevrolet Equinox EV RS, AWDSECTION Circuit/System Verification
- Vehicle Power Mode state - Service/Run
- Verify no additional Headlamp/stop lamp related DTC(s) are set and the Headlamps/stop lamps otherwise function as expected. Refer to Headlamps Malfunction
, or Turn Signal Lamps and/or Indicators Malfunction
.
- If any additional Headlamp/stop lamp-related DTC(s) are set
- Go to next step: If no additional Headlamp/stop lamp-related DTC(s) are set
- Verify DTC U1015 is not set
- If DTC U1015 is set
Refer to: Circuit/System Testing
- Go to next step: If DTC U1015 is not set
- If DTC U1015 is set
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.