Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
Always inspect for debris in both the receptacle and the charge cord that might prevent complete insertion. Snow/Ice, insects or other foreign material may prevent good electrical connection and should be removed before attempting to diagnose charging complaints.
- Vehicle On, in Service mode.
- Verify no other DTCs are set.
- If any other DTCs are set
- Go to next step: If no other DTCs are set
Go to next step: Refer to: Circuit/System Testing
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.