Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSREMOTE FUNCTION ACTUATOR MODULE REPLACEMENTREMOVAL PROCEDURE

2025 Chevrolet Equinox EV RS, AWD

Removal Procedure

2025 Chevrolet Equinox EV RS, AWDSECTION Removal Procedure

Disable the SIR system. SIR Disabling and Enabling
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Back Cushion - Right Side (3) - Remove - Rear Seat Back Cushion Removal and Installation - Right Side
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using a flat bladed plastic trim tool, release the retaining clips.
Rear Side Door Sill Garnish Molding - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Left side shown, right side similar.
- The rear seat shoulder belt guide does not need to be fully removed from the vehicle.
Using a flat bladed plastic trim tool, release the retaining clips.
Rear Seat Shoulder Belt Guide - Right Side (1) - Reposition
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Quarter Window Trim Finish Panel Bolt Cap - Right Side (2) - Remove
Quarter Window Trim Finish Panel Bolt - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using a flat bladed plastic trim tool, release the retaining clips.
Quarter Window Trim Finish Panel - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Load Floor Stowage Compartment Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Remove [4x]
Rear Compartment Floor Stowage Compartment Divider (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Liftgate Lock Striker Cover (1) - Remove
Using a flat bladed plastic trim tool, release the retaining clips.
Liftgate Sill Garnish Molding (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Convenience Net Retainer - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Cargo Tie Down Loop Bolt Cap - Right Side (1) - Remove

NOTE:

Please be advised that the cargo tie down loop requires high torque efforts to remove.

Using a breaker bar and a T40 Torx bit, loosen the cargo tie down bolt.
Cargo Tie Down Loop Bolt - Right Side (2) - Remove
Cargo Tie Down Loop - Right Side (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Quarter Trim Panel Cover - Right Side (1) - Remove
Body Lock Pillar Lower Trim Panel Bolt - Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Quarter Lower Rear Trim Panel - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Release the retaining tabs.
Remote Function Actuator Module (1) - Remove

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.