Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV RS, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK107 DRIVE MOTOR CONTROL MODULE: PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY
2025 Chevrolet Equinox EV RS, AWD
Unsuccessful Programming Recovery
2025 Chevrolet Equinox EV RS, AWDSECTION Unsuccessful Programming Recovery
If programming a control module is not successful, perform the following procedure:
- Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
- On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
- Verify the control module programming is successful.
- If the programming is not successful
- Vehicle Off. Wait for greater than 1 min.
- Vehicle OnService Mode
- On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
- If the programming is not successful, Replace the component: Drive Motor Control Module that was not able to program.
- Go to next step: If the programming is successful
- All OK.
- Go to next step: If the programming is successful
- All OK..
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.