Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
Quarter Window Trim Finish Panel Bolt Cap - Left Side and Right Side (2) - Remove [2x]
- Quarter Window Trim Finish Panel Bolt - Left Side and Right Side (1) - Remove [2x]
Using a flat bladed plastic trim tool, release the retaining clips.
- Quarter Window Trim Finish Panel - Left Side and Right Side (1) - Remove [2x]
- NOTE:
Headlining trim panel shown removed for graphic clarity.
Remove the 2 headlining trim panel retainers (3).
Disconnect the electrical connector.
- Release the retaining tab.
- UHF Low Energy Remote Control Access Sensor Transceiver - Position 5 (1) - Remove
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.