Fastener Specifications

2025 Chevrolet Equinox EV LT, AWDSECTION Fastener Specifications
GM6396335Courtesy of GENERAL MOTORS COMPANY
NOTE: Callout items in the following chart represent components shown in graphic above.
Front Seat Belts

Callout Component Name [Component Quantity] Single Use Fastener/Component Thread Locking Adhesive Required Specification Procedure
Metric (English)
1 Front Seat Belt Guide Bolt [2x] - - 45 N.m (33 lb ft) Front Seat Belt Guide Adjuster Replacement 
2 Front Seat Belt Buckle Bolt - Yes 45 N.m (33 lb ft) Front Seat Belt Buckle Replacement 
GM6407851Courtesy of GENERAL MOTORS COMPANY
NOTE: Callout items in the following chart represent components shown in graphic above.
Rear Seat Belts

Callout Component Name Single Use Fastener/Component Thread Locking Adhesive Required Specification Procedure
Metric (English)
1 Rear Seat Center Belt Retractor Nut - - 45 N.m (33 lb ft) Rear Seat Center Belt Retractor Replacement 
2 Rear Seat Belt Anchor Plate Bolt - - 45 N.m (33 lb ft) Rear Seat Belt Retractor Replacement - Left Side 
Rear Seat Belt Retractor Replacement - Right Side 
3 Rear Seat Belt Retractor Bolt [2x] - - 45 N.m (33 lb ft) Rear Seat Belt Retractor Replacement - Left Side 
Rear Seat Belt Retractor Replacement - Right Side 
4 Rear Seat Center Belt Retractor Bolt - - 45 N.m (33 lb ft) Rear Seat Cushion Cover and Pad Removal and Installation
5 Rear Seat Belt Buckle Nut [2x] - - 45 N.m (33 lb ft) Rear Seat Belt Buckle Replacement - Left Side 
Rear Seat Belt Buckle Replacement - Right Side 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.