Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX EV LT, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONSPECIFICATIONS INDEXCOMMON SPECS AND PROCEDURESCOMMON SPECS AND PROCEDURES INDEX
2025 Chevrolet Equinox EV LT, AWD
Common Specs And Procedures Index
2025 Chevrolet Equinox EV LT, AWDSECTION Common Specs And Procedures Index
COMMON SPECS AND PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | APPROXIMATE FLUID CAPACITIES | ||
| Torque | Base FASTENER SPECIFICATIONS or Automatic System FASTENER SPECIFICATIONS | ||
| Wheel Drive Shaft Nut | |||
| Front/Rear | First Pass: 330 N.m (244 lb ft) Second Pass: Loosen 45 degrees Final Pass: 270 N.m (199 lb ft) |
||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF. See BLEEDING COMPLETE BRAKE HYDRAULIC SYSTEM | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Cooling System | |||
| Electric Vehicle | APPROXIMATE FLUID CAPACITIES | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 190 N.m (140 lb ft) Evenly tighten the 6 wheel nuts in a crisscross pattern. |
||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.