Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2025 Chevrolet Equinox EV LT, AWDSECTION Installation Procedure
Hybrid/Electric Vehicle Battery Charging Disconnect Module Relay (2) - Install
- Drive Motor Battery Charger Module Relay Bolt (1) - Install and tighten [3x] - Fastener Specifications
Connect the electrical connector and install the wiring harness retainers as necessary. (2)
- Connect the high voltage electrical connector and install the wiring harness retainers as necessary. (1) High Voltage Connectors
- Enable the high voltage system. High Voltage Enabling
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.