Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX ACTIV, 4WDREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK47 POWER TRANSFER UNIT ACTUATOR CONTROL MODULE: PROGRAMMING AND SETUPCONTROL MODULE SETUP
2025 Chevrolet Equinox ACTIV, 4WD
Control Module Setup
2025 Chevrolet Equinox ACTIV, 4WDSECTION Control Module Setup
To program a replacement control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K20 Engine Control Module - DSAM Prepare Module for Removal and follow the on-screen instructions.
- Replace the necessary driveline component(s).
- On the SPS Supported Controllers screen, select K20 Engine Control Module - DSAM Setup and follow the on-screen instructions.
- Clear DTCs.
NOTE:
Steps 1-2 must be performed BEFORE the old K47B Power Transfer Unit Actuator Control Module is removed from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.