Keyless Entry Control Module Replacement (Equinox)

2025 Chevrolet Equinox ACTIV, 4WDSECTION Keyless Entry Control Module Replacement (Equinox)
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
GM4597147Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Quarter Lower Rear Trim Panel Replacement (Left Side) , or Quarter Lower Rear Trim Panel Replacement (Right Side)
1 Keyless Entry Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Release the retaining tabs.
  3. Perform the necessary programming and setup procedure:Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.