Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX ACTIV, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 55 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSB174W FRONTVIEW CAMERA - WINDSHIELD: PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY
2025 Chevrolet Equinox ACTIV, 4WD
Unsuccessful Programming Recovery
2025 Chevrolet Equinox ACTIV, 4WDSECTION Unsuccessful Programming Recovery
WARNING: This page is about a different car, the 2024 GMC Terrain and 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
In the event of an interrupted or unsuccessful programming event, perform the following steps:
- DO NOT turn the ignition OFF. Ensure that all B174W Frontview Camera - Windshield, DLC and programming tool connections are secure and the TIS terminal operating software is up to date.
- Attempt to reprogram the B174W Frontview Camera - Windshield.
- If the B174W Frontview Camera - Windshield can still not be programmed, turn the ignition OFF for at least one minute.
- Turn the ignition ON and attempt to reprogram the B174W Frontview Camera - Windshield. The B174W Frontview Camera - Windshield should program.
- If the B174W Frontview Camera - Windshield still cannot be programmed, replace the B174W Frontview Camera - Windshield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.