Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Wireless Charging System Module Bracket - Install
- Wireless Charging System Module Bracket Bolt (1) - Install and tighten [4x] 1 N.m (9 lb in)
Wireless Charging System Module Bracket (2) and Wireless Charging System Module (3) - Install
- Connect the electrical connector.
- Front Floor Lower Console Bolt (1) - Install and tighten [4x] 2.5 N.m (22 lb in)
Front Floor Console Trim Plate (1) - Install - Front Floor Console Trim Plate Replacement (Equinox) , or Front Floor Console Trim Plate Replacement (Terrain)
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.