Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Rear Wheel Speed Sensor (1) - Install
- CAUTION:
Refer to Fastener Caution .
Rear Wheel Speed Sensor Bolt (1) - Install and tighten - Fastener Specifications
Wiring Harness Retainer (1) - Secure
- NOTE:
Some components not shown for graphic clarity.
Wiring Harness Retainer (1) - Secure [3x]
Wiring Harness Retainer (3) @ Rear Suspension Cradle - Secure
- Electrical Connector (1) @ Rear Wheel Speed Sensor (2) - Connect
- Remove the support and lower the vehicle. Lifting and Jacking the Vehicle
- Perform the diagnostic system check. Diagnostic System Check - Vehicle
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.