Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Apply a light coat of wheel speed anti-corrosion grease to the front wheel speed sensor (2) and mounting pad on the steering knuckle. Adhesives, Fluids, Lubricants, and Sealers
- Front Wheel Speed Sensor (2) - Install
- Front Wheel Speed Sensor Bolt (1) - Install and tighten - Fastener Specifications
Wiring Harness Grommet (3) - Install
- Wiring Harness Retainer (2) - Install
- Wiring Harness Retainer (1) - Install [2x]
Wiring Harness Retainer (1) - Install [2x]
Wiring Harness Retainer (2) - Install [2x]
- Electrical Connector (1) - Connect
{ If equipped } Wiring Harness Grommet (2) - Install
- { If equipped } Wiring Harness Retainer (1) - Install
{ If equipped } Front Disc Brake Pad Wear Sensor (1) - Connect
- Front Wheelhouse Liner - Install - Front Wheelhouse Liner Replacement - Left Side
- Perform the diagnostic system check. Diagnostic System Check - Vehicle
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.